Hiab K-HiPro Crane Column
Hiab recalls K-HiPro 425 and 505 cranes due to weld fatigue that may cause column collapse.
Stop using the crane immediately and contact your authorized Hiab dealer to schedule an inspection and repair. Do not operate the crane until the weld has been inspected and, if necessary, repaired.
Recall at a glance
- Vehicles affected
- 996
- Repair cost
- Free of charge
- Owner letters expected
- September 18, 2026
- Manufacturer phone
- (844) 442-2911
Why it was recalled
Hiab USA Inc. is recalling certain K-HiPro 425 and K-HiPro 505 cranes because the weld between the column pillar and the main plate may fatigue and crack over time. A cracked weld can cause the crane column to collapse during use, posing an injury risk to the operator or bystanders.
Is mine affected?
This recall covers specific vehicles. Look up your VIN at nhtsa.gov/recalls or check with the manufacturer to confirm yours is included.
HIAB K-HIPRO 425, EQUIPMENT
Where it was sold
Distributed nationwide.
Timeline
- Reported to NHTSA
- Listed on Recall Canary
- Summary updated
Other Vehicle Equipment Defect recalls
Other recent recalls from Hiab USA Inc.
Editorial summary by Recall Canary · summary updated 2026-08-22 · primary source: U.S. National Highway Traffic Safety Administration · severity reflects the agency's published classification