Terex Pole Guide Arm Assembly Pin
Terex is recalling pole guide arm assembly pins (part 450543) due to cracked welds that may cause the arm to fall.
Stop using the affected pole guide arm assembly pins with part number 450543 immediately. Contact Terex South Dakota, Inc. for instructions on inspection, repair, or replacement.
Recall at a glance
- Vehicles affected
- 3,015
- Repair cost
- Free of charge
- Owner letters mailed
- June 2, 2026
- Manufacturer's recall number
- SN737E
- Manufacturer phone
- 1-605-882-4000
Why it was recalled
Terex South Dakota, Inc. is recalling certain pole position guide arm assembly pins with part number 450543 due to an insufficient weld on the plate weldment that may crack and cause the retaining pin to separate. Without the retaining pin, the pole guide arm may fall, increasing the risk of injury.
Is mine affected?
This recall covers specific vehicles. Look up your VIN at nhtsa.gov/recalls or check with the manufacturer to confirm yours is included.
TEREX POLE POSITION GUIDE ARM ASSEMBLY PIN
Where it was sold
Distributed nationwide.
Timeline
- Reported to NHTSA
- Listed on Recall Canary
- Summary updated
Other recent recalls from Terex South Dakota, Inc.
Editorial summary by Recall Canary · summary updated 2026-04-27 · primary source: U.S. National Highway Traffic Safety Administration · severity reflects the agency's published classification