NHTSA recall,
Hale Weldon UV800 Display Units
The Weldon UV800 Display Unit may fail to respond to touch or power on, preventing activation of emergency lights and equipment.
What happened
Hale Products Inc is recalling certain Weldon UV800 Display Unit user interfaces. The display may stop responding to touch commands or fail to power on, preventing the activation of exterior emergency lights, fire fighting and other emergency equipment. A loss of exterior lights can reduce the visibility of the vehicle to other drivers, increasing the risk of a crash. Inoperative equipment can delay emergency response, increasing the risk of injury.
The recall was reported to NHTSA on May 13, 2026, and the units were distributed nationwide. Hale will update the firmware and install a monitor system, free of charge. Hale is expected to notify the affected vehicle manufacturers May 17, 2026.
What to do
If yours is included:
- Hale will update the firmware and install a monitor system, free of charge.
- You may contact Hale customer service at 1-800-533-3569.
What you get Free repair
Full text from NHTSA
Hale will update the firmware and install a monitor system, free of charge. Hale is expected to notify the affected vehicle manufacturers May 17, 2026. Owners may contact Hale customer service at 1-800-533-3569. Hale's number for this recall is SB-189.
Is yours affected?
Check yours against the codes the NHTSA notice names below.
Weldon UV800 Display Unit, Equipment
From the NHTSA notice
Hale Products Inc (Hale) is recalling certain Weldon UV800 Display Unit user interfaces, with part numbers 610-00060-080-51, 610-00060-080-50, 610-00060-081, and 610-00091.
Recall details
- Reported to NHTSA
- Sold in
- Nationwide
- Manufacturer
- Hale Products Inc
- Component
- Vehicle equipment defect
- Campaign
- 26E030000
- Units affected
- 116
- Repair cost
- Free of charge
- Manufacturer's recall number
- SB-189
- Manufacturer phone
- 1-800-533-3569
Timeline
Reported to NHTSA
Listed on Recall Canary
Summary updated



